That button may be to the left when you open the panel but it could also be in different positions depending on the model of your RV. For combination gas and electric water heaters, that reset button may be located out in the WH panel outside your RV. However, the trick is in finding the reset button. Most water heater systems come with a reset button and all you have to do is push it to get the water heater back online and working again. This is not really a hard task to perform. In contrast to the pilot light which will stay lit until you turn the gas supply off. Often, the DSI control will try 3 times to light the gas, and when it fails all three times it locks out the gas supply.Īlso, the DSI control board will turn off the ignition once the set temperature has been reached. The DSI system removes that danger as it shuts off the gas flow when certain issues are detected like the gas failed to light. If the pilot light did not stay lit then you could be pumping propane into your RV setting yourself up for possible problems. In the old days, to get hot water, you had to exit your RV and go around to where the ignition was and manually light the pilot light. This system is produced by both Atwood and Suburban and is said to be one of the safer systems you can use in an RV. What this device does is automatically light the gas once the power switch has been turned on. Direct spark ignition are the three words that go with the three letters- DSI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |